Цифровой манометр Keller, LEO 3

ntelligent Transmitter with Digital Indication

LEO 3 is a micro-processor based transmitter with digital double-display for pressure (top display) and for the output signal (bottom display). The display is powered from the 4...20 mA current loop.

The following functions can be executed with the front keys:

MAX/MIN:
Activating the right key brings the Max.- and Min.-values to the lower display. After 5 seconds, the analog signal is indicated again.

RESET:
With RESET, the Max.- and Min.-values are set to actual.

ZERO SET:
The zero is set to the applied pressure.

ZERO RES:
Restores the instrument back to factory settings.

UNITS:
The pressure values can be displayed in the following units:
bar, mbar/ hPa, kPa, MPa, PSI, kp/cm2.

Programming the Analog Output via the front Keys:

OUTP SETT:
This sub-menu is used to configure the analog output within the compensated range.

ZERO:
Executing ZERO when pressure is applied sets the analog output to 4 mA.

FS:
Executing FS when pressure is applied sets the analog output to 20 mA.

FACT SETT:
The analog output is set back to factory settings.

Programming by PC:

The communication with the BUS-capable instrument takes place with the KELLER READ30/PROG30 software and a KELLER converter (K104B, K107,…) via the RS 485 interface, allowing to read out the pressure values and the instrument characteristics. The analog output can be programmed without applying pressure to the instrument.
Pressure Ranges

0...4 bar abs.
0...30 bar abs.
0...300 bar
0...700 bar
0...1000 bar
Total Error Band (0…50 °C) < 0,2 %FS
Storage Temperature -10...60 °C
Compensated Temperature Range 0...50 °C
Protection

IP65

Информация

Код товара 20116

Производитель KELLER (Switzerland)

Артикул производителя LEO 3

Условия поставки Под заказ

Цена : Цену уточняйте: radioniсs@mail.ru

Оформить заказ можно здесь:

Заказать

Добавить в корзину

Цифровой манометр Keller, LEO 3

Цифровой манометр Keller, LEO 3

Контакты

Ваша корзина

Вход для клиентов

Информация